You are currently viewing Insignia NS-UZ17XWH7 17 / 21 Cu. Ft. Freezer User Manual

Insignia NS-UZ17XWH7 17 / 21 Cu. Ft. Freezer User Manual

Insignia LOGO

Insignia NS-UZ17XWH7 17 / 21 Cu. Ft. Freezer

 

 

Insignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-product

Insignia NS-UZ17XWH7 17 / 21 Cu. Ft. Freezer User Manual.

PACKAGE CONTENTS

  • 17 or 21-cubic-foot upright freezer
  • Door handle, screws, and hex wrench
  • Quick Setup Guide

SETTING UP YOUR FREEZER

Before using your freezer

  • Remove the exterior and interior packing.
  • Let the freezer stand upright for approximately two hours before connecting it to power.
  • Wipe the inside.
  • When moving your freezer, do not tilt it beyond 45° from upright.

Finding a suitable location

  • Allow 7.9 inches (20 cm) of space between the sides of the freezer and the walls, 3.9 inches (10 cm) between the back of the freezer and the wall, and 11.8 inches (30 cm) between the top of the freezer and the ceiling.
  • If you locate the freezer next to a fixed wall, allow sufficient space on the hinge side for the door to swing open.
  • Locate the freezer away from direct sunlight and sources of heat, such as a stove, heater, or radiator. Direct sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extremely cold temperatures may also prevent the freezer from performing properly.
  • Avoid locating the freezer in moist areas

Leveling your freezer

  • To level your freezer, rotate the leveling feet clockwise (to raise) the freezer or counter-clockwise (to lower). The front of the freezer should be slightly higher than the back.

Installing the door handle

  1. Unplug the freezer.
  2. Screw the extended-head screws into the door holes with a Phillips screwdriver. Do not over tighten. The screw heads should extend above the surface of the doorInsignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-fig-1
  3. Loosen the hex screws on the top and bottom of the handle with the hex wrench (provided) so that you can fit the handle over the extended head screws in the doorInsignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-fig-2
  4. Place the door handle over the heads of the screws, then tighten the hex screws

USING YOUR FREEZER

  1. Plug in your freezer. Wait for 30 minutes, then open the freezer door to determine if the freezer is working properly.
  2. Press and hold the Lock button for three seconds, then + or – to set the temperature inside the freezer.

Using the Lock button

  • To prevent accidental activation, the control panel automatically locks after 30 seconds of inactivity. To use the control panel, press and hold the Lock button for three seconds.

Switching between Freezer and Refrigerator modes

This freezer has an advanced design feature that lets you change it from a freezer to a refrigerator. Using the control panel on the freezer

  1. Press and hold the Lock button for three seconds.
  2. Press and hold the Freezer/Fridge button for three seconds. The panel beeps and the indicator changes to the new mode.

Quick Freezing foods

  • The quick freeze mode lowers the temperature below the average operating temperature to quickly freeze foods. You can only use the control panel to quickly freeze foods.

Using the control panel on the freezer

  1. Press and hold the Lock for three seconds.
  2. Press the Quick Freeze button to enter Quick Freeze mode. The blue snowflake turns on.
  • The quick freeze mode turns off after three hours if the temperature falls below -13° F (-25° C). If the temperature does not fall below -13° F (-25° C), the quick freeze mode turns off after 24 hours. You can press the button a second time to exit quick freeze mode

Switching between Fahrenheit and Celsius

Using the control panel on the freezer

  1. Press and hold Lock for three seconds to unlock the control panel.
  2. Press and hold + and – for three seconds to switch settings.

FEATURES

Interior (NS-UZ17XWH7 & NS-UZ21XWH7)Insignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-fig-3

Interior (NS-UZ17XSS9)Insignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-fig-5

Touch pad controlsInsignia-NS-UZ17XWH7-17-21-Cu.-Ft.-Freezer-fig-4

TROUBLESHOOTING

For troubleshooting information see your online User Guide

SPECIFICATIONS

For specifications see your online User Guide

SAFETY INFORMATION 

  1. Read these instructions.
  2. Keep these instructions.
  3. Heed all warnings.
  4. Follow all instructions.
  5. Do not use this appliance near water.
  6. Clean only with a damp cloth.
  7. Do not block any ventilation openings. Install by the manufacturer’s instructions.
  8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus that produce heat.
  9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two blades one wider than the other. A grounding-type plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for the replacement of the obsolete outlet.
  10.  Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and the point where they exit from the appliance.
 Do not
  1. attempt to modify or extend the power cord of this appliance.
  2.  Unplug this appliance during lightning storms or when it will not be used for long periods.
  3.  Ensure that the available AC power matches the voltage requirements of this appliance.
  4.  Do not handle the plug with wet hands. This could result in an electric shock.
  5.  Unplug the power cord by holding the plug, never by pulling the cord.
  6.  Do not turn the appliance on or off by plugging or unplugging the power cord.
  7.  Refer all servicing to qualified service personnel. Servicing is required when the appliance has been damaged in any way, such as the power-supply cord or plug is damaged, liquid has been spilled or objects have fallen into the appliance, the appliance has been exposed to rain or moisture, does not operate normally, or has been dropped.
  8.  Do not use extension cords or ungrounded (two-prong) adapters.
  9.  This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
  10.  Children should be supervised to ensure that they do not play with the appliance.
  11.  If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or a similarly qualified person to avoid a hazard.
  12.  Risk of child entrapment. Before you throw away your old freezer:
    1. Take off the doors
    2. Leave the shelves in place so that children may not easily climb inside
Grounding requirement

This freezer must be grounded. This freezer is equipped with a cord having a grounding wire with a grounding plug. The plug must be inserted into an outlet that is properly installed and grounded. Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or service person if the grounding instructions are not completely understood, or if doubt exists as to whether the freezer is properly grounded.

LEGAL NOTICES
lf at any time in the future you should need to dispose of this product, note that waste electrical products should not be disposed of with household waste. Recycle where facilities exist. Check with your Local Authority or retailer for recycling advice.

ONE-YEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.

CONTACT INSIGNIA
For customer service, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico) www.insigniaproducts.com

Download Link

Get Manual

Leave a Reply