Insignia NS-RTM18BS8 18 Cu. Ft Refrigerator User Manual

Insignia NS-RTM18BS8 18 Cu. Ft Refrigerator

Insignia NS-RTM18BS8 18 Cu. Ft Refrigerator User Manual.

Introduction

Insignia NS-RTM18BS8 18 Cu. Ft Refrigerator User Manual. Congratulations on your purchase of a high-quality Insignia product. Your NS-RTM18BS8, NS-RTM18WH7, NS-RTM18SS7, NS-RTM18BKR8, NS-RTM18WH7-C, NS-RTM18SS7-C, NS-RTM18BK8L, or NS-RTM18SS7L represents the state of the art in refrigerator design and is designed for reliable and trouble-free performance.

Important Safety Instructions

WARNING

Electric Shock Hazard Failure to follow these instructions can result in electric shock, fire, or death.

1. Keep ventilation openings in the appliance clear of obstruction.
2. Do not touch the interior of the freezer compartment with wet hands. This could result in frostbite.
3. Do not use mechanical devices or other means to accelerate the defrosting process, other than those recommended by the manufacturer.
4. Do not damage the refrigerant tubing when handling, moving, or using the refrigerator.
5. Do not use electrical appliances inside the food storage compartment of the refrigerator, unless they are of the type recommended by the manufacturer.

Features

• 18 cubic foot capacity
• Electronic control
• Glass spill-safe shelves
• Humidity-controlled crisper drawers
• LED lighting
• Frost free

Package contents

• 18 cu. ft. top-mount refrigerator
• Hinge kit
• User Guide

Main components

Note: This illustration shows a right-opening refrigerator. Left-opening models are configured the same, except they open from right to left.

Setting up your refrigerator

Insignia NS-RTM18BS8 18 Cu. Ft Refrigerator User Manual.

Before using your refrigerator

1. Remove the interior packing.
2. Let the refrigerator stand upright for approximately four hours before connecting it to power. This reduces the possibility of a malfunction in the cooling system from improper handling during transportation.
3. Clean the interior surface with lukewarm water using a soft cloth.
4. Wait for approximately 24 hours after the thermostat has been set before placing any food in your refrigerator.

Finding a suitable location

• This refrigerator is designed to be free-standing only.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is fully loaded.
• Position the refrigerator in a location away from direct sunlight, because it may affect the acrylic coating, and heat sources may increase electrical consumption. To ensure optimal performance, install in areas with an ambient temperature between 41° F (5° C) and 109° F (42.8° C).
• Avoid locating the refrigerator in moist areas.
• The refrigerator door must be able to swing fully open.

Leveling your refrigerator

• The refrigerator needs to be level. If the refrigerator is not leveled during installation, the doors may not close or seal properly, causing cooling, frost, or moisture problems.
• To level your refrigerator, rotate the leveling feet clockwise (to raise) the refrigerator or counter-clockwise (to lower).

Note: Having someone push against the top of the refrigerator helps to take some weight off the leveling foot, making it easier to adjust

Providing proper ventilation
Place the refrigerator at least one inch from the wall on each side to ensure proper airflow to the compressor. Do not place the refrigerator near any heat sources, such as a heater or stove, as this may put a strain on the compressor.

Providing a proper power supply

Check your local power source. This refrigerator requires a 110 V-120 V, 60 Hz power supply. Use a receptacle that accepts the grounding prong. The power cord is equipped with a 3-prong (grounding) plug which mates with a standard 3-prong (grounding) wall outlet to minimize the possibility of electric shock hazards from this refrigerator

Notes:

• The refrigerator should always be plugged into its electrical outlet which has a voltage rating that matches the rating plate.
• Never unplug your refrigerator by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet.

Using your refrigerator

Setting the refrigerator temperature

• The first time you turn the refrigerator on, the control panel LEDs turn on for three seconds, then display the current setting (default = 3). Your refrigerator runs continuously for several hours until it reaches the preset temperature.
• To temporarily suspend cooling in the refrigerator and freezer, press and hold the SET button for three seconds. Press the SET button again to cancel standby mode and resume cooling.

Notes:

• If the refrigerator is unplugged or loses power, you must wait three to five minutes before restarting it. If you attempt to restart before this time delay, the refrigerator will not start.
• Large amounts of food will lower the cooling efficiency of the refrigerator.
• If you choose to change the thermostat setting, adjust it by one increment at a time. Allow 24 hours for the temperature to stabilize between adjustments.

Setting the freezer temperature

Turn the controls to adjust the freezer temperature, and allow 24 hours for the freezer to adjust and stabilize.

Using the freezer compartment

• Place frozen food into the freezer as quickly as possible after purchase.
• Follow package instructions regarding storage times. The storage life of frozen foods varies and the recommended storage time should not be exceeded.

Reversing the door position
Based on the location where you plan to use your refrigerator, you may find it more convenient to reverse the position of the door.

CAUTION: To avoid injury to yourself or your property, we recommend that someone assist you during the door reversal process

Preparing to reverse the door position

Note: Images show a refrigerator that initially opens on the left side. However, your refrigerator may open on the right side.

You will need A standard (flathead) screwdriver and a Phillips screwdriver.

• Make sure that your refrigerator is unplugged and empty.
• Have someone available to assist you in the process.
• Keep all of the parts you remove to reuse them later.

Reversing the door position

Note: Right-opening model is shown for illustration purposes.

Parts included with the hinge kit:

Parts you’ll use

1. Unplug your refrigerator and remove all food from the door shelves
2. Remove the cover plate and the top hinge cover, then unscrew and remove the top hinge. Keep the screws to reuse
3. Lift the freezer door up and away from your refrigerator.
   
4. Unscrew the hinge pin from the bottom hinge and reattach it to the other hole in the hinge pin, then secure the bottom hinge to the opposite side of the refrigerator using the screws you removed previously.
5. Remove the hole caps and plastic bushings from the top of the freezer and refrigerator doors. Save them for the next step
6. Remove the door block from the bottom of the refrigerator door and attach it to the other side.
7. Attach the upper door self-locking block and the door-open stopper to the side of the freezer door where the hinge will be. Use the parts from the hinge kit.
8. Attach the refrigerator door to the bottom hinge, then attach the center hinge to the refrigerator. Use the center hinge from the hinge kit (not the piece
   removed in step 4)
9. Put the freezer door onto the center hinge, then attach the top hinge (from the hinge kit) to the top of the refrigerator.
10. Add covers to the screw holes and hinge pivot

CAUTION:

To prevent damage to the finish, do not use:

• Gasoline, benzine, thinner, or other similar solvents.
• Abrasive cleaners

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Wash the inside with a damp warm cloth soaked in a solution of one quart of lukewarm water to two tablespoons of baking soda solution.
4. Be sure to keep the door gasket (seal) clean to keep the refrigerator running efficiently.
5. Dry the interior and exterior with a soft cloth

Changing the interior LED light

1. Using a Phillips screwdriver, remove the screw securing the lamp cover, then remove the lamp cover
2. Remove the LED light bulb from the lamp base, then install a new LED light bulb.
3. Reinstall the lamp cover with the screw you previously removed.

Shutting down your refrigerator – long vacations (several months)

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Clean the refrigerator.
4. Leave the door open slightly to avoid possible formation of condensation, mold, or odor.

Moving your refrigerator

1. Turn off the refrigerator and unplug it from the wall outlet.
2. Remove all food.
3. Securely tape down all loose items inside your refrigerator.
4. Tape the doors shut. Be sure the refrigerator stays in the upright position during transportation.

Tips on saving energy

• Locate your refrigerator in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.
• Let hot foods cool before placing them in the refrigerator. Overloading the refrigerator forces the compressor to run longer. Foods that freeze too slowly may lose quality or spoil.
• Wrap foods properly and wipe containers dry before placing them in the refrigerator. This cuts down on frost build-up inside the refrigerator.
• Organize and label food to reduce door openings and extended searches.

Troubleshooting

CAUTION: Do not try to repair your refrigerator yourself. Doing so invalidates the warranty.

Error codes

• LED display Problem
• LED 1 and LED 2 lit Temperature sensor circuit
• LED 1 and LED 3 lit Freezer defrost sensor
• LED 1 and LED 4 lit Ambient temperature sensor

Specifications

ONE-YEAR LIMITED WARRANTY

Definitions:

The Distributor* of Insignia branded products warrants to you, the original purchaser of this new Insignia-branded product (“Product”), that the Product shall be free of defects in the original manufacturer of the material or workmanship for one (1) year from the date of your purchase of the Product (“Warranty Period”). For this warranty to apply, your Product must be purchased in the United States or Canada from a Best Buy branded retail store or online at www.bestbuy.com or www.bestbuy.ca and is packaged with this warranty statement. NS-RTM18BS8  Refrigerator User Manual.

How long does the coverage last?
The Warranty Period lasts for 1 year (365 days) from the date you purchased the Product. Your purchase date is printed on the receipt you received with the Product.

What does this warranty cover?

During the Warranty Period, if the original manufacture of the material or workmanship of the Product is determined to be defective by an authorized Insignia repair center or store personnel, Insignia will (at its sole option): (1) repair the Product with new or rebuilt parts, or (2) replace the Product at no charge with new or rebuilt comparable products or parts. Products and parts replaced under this warranty become the property of Insignia and are not returned to you. If service of Products or parts is required after the Warranty Period expires, you must pay all labor and parts charges. This warranty lasts as long as you own your Insignia Product during the Warranty Period. Warranty coverage terminates if you sell or otherwise transfer the Product.

How to obtain warranty service?

If you purchased the Product at a Best Buy retail store location or from a Best Buy online website (www.bestbuy.com or www.bestbuy.ca), please take your original receipt and the Product to any Best Buy store. Make sure that you place the Product in its original packaging or packaging that provides the same amount of protection as the original packaging. To obtain warranty service, in the United States and Canada call 1-877-467-4289. Call agents may diagnose and correct the issue over the phone.

Where is the warranty valid?
This warranty is valid only in the United States and Canada at Best Buy branded retail stores or websites to the original purchaser of the product in the country where the original purchase was made. NS-RTM18BS8 Refrigerator User Manual.

What does the warranty not cover?
This warranty does not cover:

• Customer instruction/education
• Installation
• Set up adjustments
• Cosmetic damage
• Damage due to weather, lightning, and other acts of God, such as power surges
• Accidental damage
• Misuse
• Abuse
• Negligence

Contact Insignia:

• 1-877-467-4289
• www.insigniaproducts.com

INSIGNIA is a trademark of Best Buy and its affiliated companies. *Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. 2020 Best Buy. All rights reserved

www.insigniaproducts.com 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)

INSIGNIA is a trademark of Best Buy and its affiliated companies. Distributed by Best Buy Purchasing, LLC 7601 Penn Ave South, Richfield, MN 55423 U.S.A. ©2020 Best Buy. All rights reserved

Download PDF

For More Manual