Garmin GC100 Wireless Camera
Getting Started
WARNING
See the Important Safety and Product Information guide in the product box for product warnings and other important information.
Mounting Considerations
- You must mount the camera in a location where it is not submerged.
- You should mount the camera within 76 m (250 ft.) of a chartplotter. The range depends on your installation location and the obstacles between the camera and the chart plotter. If the camera is out of range of the chartplotter due to obstacles or distance, you must reposition the camera.
- You should test the camera in your desired location before you permanently mount the camera.
- You should mount the camera so that the cable can be connected easily.
- You should mount the camera in a location where it cannot be damaged by docks, pilings, or other pieces of equipment.
- You should mount the camera so it does not present a hazard in doorways or walkways.
- You should mount the camera in a location where you can remove the camera
Mounting the Camera
- Using a 3.2 mm (1 /8 in.) drill bit, drill a pilot hole.
- Using the included screw, fasten the camera mount to the mounting surface.
- Insert the camera into the housing.
- Close the front of the housing.
- Tighten the tamper-proof side screws using the included tool.
- Connect the power cable.
Connecting to Power
WARNING
When connecting the power cable, do not remove the in-line fuse holder. To prevent the possibility of injury or product damage caused by fire or overheating, the appropriate fuse must be in place as indicated in the product specifications. In addition, connecting the power cable without the appropriate fuse in place voids the product warranty.
- Route the power cable to the power source and the device.
- Connect the red wire to the positive (+) battery terminal, and connect the black wire to the negative (-) battery terminal.
Pairing
Before you can connect a wireless device to the Chartplotter wireless network, you must configure the Chartplotter wireless network. See your chartplotter manual for information on configuring the wireless network
- With the camera within an unobstructed 76 m (250 ft.) of the
chartplotter, quickly press three times. - On the chart plotter, select Settings > Communications >
Wireless Devices > Garmin Camera > Start. - Follow the on-screen instructions.
Turning the Camera Off
Hold for 3 seconds.
Specifications
GC 100 Blink Codes
The color and blink sequence of the status LED on the camera indicates its operational status.
- The device withstands incidental exposure to water of up to 1 m for up to 30 min. For more information, go to www.garmin.com/waterrating
© 2018 Garmin Ltd. or its subsidiaries Garmin® and the Garmin logo are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries. GC™ is a trademark of Garmin Ltd. or its subsidiaries. Wi‑Fi® is a registered mark of Wi-Fi Alliance Corporation