Cuisinart EM-400 Serve Espresso & Coffee Machine
Cuisinart EM-400 Serve Espresso & Coffee Machine User Manual.
IMPORTANT SAFEGUARDS
We at Cuisinart are very safety conscious. We design and manufacture consumer products with the safety of you, our valued customer, foremost in mind. Read this Cuisinart EM-400 Serve Espresso & Coffee Machine User Manual When using electrical appliances, basic safety precautions should always be followed, including the following:
- Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts, and before cleaning the appliance.
- To protect against fire, electrical shock, and injury to persons, do not immerse the appliance, cord, or plug in water or any other liquids.
- This appliance is for household use only.
- Do not operate the unit with the brewing head open.
SPECIAL SAFETY INSTRUCTIONS
- Use only cold water in the water reservoir. Do not use any other liquid.
- Never use the machine without water in it.
SPECIAL CORD SET INSTRUCTIONS
A short power-supply cord is provided to reduce the risks resulting from becoming entangled in or tripping over a longer cord. Longer extension cords are available and may be used if care is exercised in their use. If a long extension cord is used, the marked electrical rating of the extension cord must be at least as great as the electrical rating of the appliance. Cuisinart EM-400 Serve Espresso & Coffee Machine User Manual.
NOTICE
IMPORTANT UNPACKING INSTRUCTIONS
- Place the box on a large, sturdy, flat surface.
- Remove the instruction book and any other literature.
- Remove the sample pack of illy® iperEspresso® capsules.
- Turn the box so that the backside of the machine is down, and slide the espresso maker from the box.
- Remove all packing materials, tape, etc.
- Cuisinart EM-400 Serve Espresso & Coffee Machine User Manual.
INTRODUCTION
Cuisinart and Illy are proud to introduce the Buona Tazza® Single Serve Espresso & Coffee Machine. Powered by Cuisinart, the machine features the proprietary illy® iperEspresso® capsule system. The combination of Cuisinart’s excellence in coffeemakers and Illy’s legendary coffee heritage allows you to savor the extraordinarily smooth taste of an illy® espresso or traditional coffee. Cuisinart EM-400 Serve Espresso & Coffee Machine User Manual.
FEATURES AND BENEFITS
- Water Reservoir Lid
- Removable 34-ounce Water Reservoir
- Cup-Warming Plate
Convenient place to warm cups. - 19 Bar Pump (not shown)
- Brew Head Lever
Use the die-cast metal lever to open and close the brew head. - Brew Head
Holds illy® iperEspresso® capsules. - Brewing Spout
Strategically positioned for optimal results. - Used Capsule Container
Holds approximately 10 capsules. Also contains some residual liquid left after brewing. - Espresso Cup Tray
- Drip Tray Grate
PREPARING YOUR ESPRESSO MACHINE
- Place the espresso machine on a dry, stable countertop or other flat, sturdy surface where you will be using the machine.
- Insert the plug into a power outlet. Press the power button once to turn the espresso machine on. All of the controls on the front of the machine will flash while it’s preheating.
- Place a mug on the drip tray.
NOTE: If the water reservoir is empty or not properly positioned, the unit will not function. The SHORT, LONG, and COFFEE LEDs will flash quickly. Turn off the machine, fill the water reservoir, and turn the machine back on. We recommend brewing a short espresso without a capsule in place to prime the machine. The machine is now ready to use.
USING YOUR ESPRESSO MACHINE
NOTE: This machine is designed exclusively for use with the illy® iperEspresso® capsule system. No other type of capsule, pod, or coffee can be used. To make espresso, use an illy® espresso capsule. To make a traditional coffee, use an illy® coffee capsule.
Short or Long Pre-Programmed Espresso
- Using the lever, open the brew head, insert an espresso capsule, and close the brew head.
- With an espresso cup on the espresso cup tray, select either a SHORT (1.2 ounces) or LONG (3 ounces) espresso. (The chosen setting and, if applicable, the temperature setting LEDs remain on, while all the other LEDs are off. Once all LEDs are on again, the machine is ready for the next cycle.)
For optimal results, we recommend using the LONG button with the blue Lungo iperEspresso® capsule. Using this setting with other iperEspresso® varieties will alter the taste.
Pre-Programmed Coffee
- Using the lever, open the brew head, insert a coffee capsule, and close the brew head.
- With a coffee cup or mug on the drip tray, select COFFEE (approximately 6 ounces). (The coffee setting and, if applicable, the temperature setting LEDs remain on, while all the other LEDs are off. Once all LEDs are on again, the machine is ready for the next cycle.)
Reminder: There is no need to rinse in between cycles as there will be no transfer of flavor. See the Espresso section NOTE on the previous page.
Manual/Adjustable Strength Control
- Using the lever, open the brew head, insert a capsule, and close the brew head.
- For adjustable strength control, use the MANUAL button to adjust the length of time espresso or coffee is dispensing – the longer you allow it to flow, the lighter it will be. Press to start dispensing. When your cup is filled to the desired level, press again to stop. The manual function will time out after 90 seconds.
PROGRAMMING A CUSTOM SETTING
At ready mode, press and hold MANUAL for 3 seconds to customize the SHORT, LONG, and COFFEE output.
- are flashing and are ON. If no action is taken within 30 seconds, the unit returns to preheat/ready mode.
- Press, or button.
- The chosen setting and LEDs remain on.
To reset any setting to factory default (at ready mode), press and hold and choose the setting at the same time for 3 seconds.
- or LEDs flash 3 times.
- The default setting is on and the unit will return to preheat/ready mode.
TEMPERATURE CONTROLS
Extra-hot is the default setting. If hot is desired, press and hold the button for 3 seconds to allow the temperature to decrease. The flashing light will turn off when it has reached the lower temperature.
ENERGY-SAVER MODE
After 30 minutes of non-use, the espresso machine will automatically switch to sleep mode and all the control lights will be dimmed by about 50%. When any button is pressed, the espresso machine will return to preheat mode and all the lights will flash. The machine is ready to operate when all the lights are steady again.
AUTO-OFF MODE
Following the 30-minute Energy Saver cycle, if there is an additional 30 minutes of non-use, the espresso machine will turn off. Press the power button to turn on again.
CLEANING AND MAINTENANCE
Cleaning Used Capsule Container Container holds approximately 10 capsules and some residual liquid after brewing. Be sure to empty the container of any used capsules periodically. The container is top-shelf dishwasher safe and may also be cleaned with warm, soapy water.
- Cleaning External Parts
We recommend regular cleaning of the espresso maker’s external components. - Cleaning the Housing
Never immerse the machine in water or other liquids. The housing may be cleaned with a soapy, damp, non-abrasive cloth. - Cleaning the Drip Tray
To remove the drip tray, simply slide it toward you, keeping it level at all times to prevent spills. - Cleaning the Water Reservoir
The water reservoir is top-shelf dishwasher safe. It is normal over time for discoloration, spotting, or staining to appear in the water reservoir.
Decalcification
Mineral content in water varies from place to place. Depending on the mineral content of the water in your area, calcium deposits or scales may build up in your machine. Though scale is non-toxic, it can hinder performance.
NOTE: The unit can still be used until you decalcify.
To begin, you will need the following:
- 6 ounces distilled white vinegar
- 6 ounce water
- 1 large (12 ounces) ceramic mug or container (do not use paper cup)
Step 1: Vinegar Rinse
- Fill the water reservoir with 6 ounces of water and 6 ounces of white vinegar and replace.
- Place the ceramic mug or container on the drip tray.
- Lift the brew head lever to make sure there is no capsule inside.
Step 2: Fresh Water Rinse
- Fill the water reservoir with clean, fresh water.
- Replace the ceramic mug or container on the drip tray.
- Press the MANUAL M button and the unit will dispense water for approximately 90 seconds.
- This will clean the machine’s plumbing and remove any residual vinegar taste.
Maintenance: Any other servicing should be performed by an authorized service representative.
TROUBLESHOOTING
Problem: The machine does not have power.
Solution:
- Make sure the machine is securely plugged in.
- Reset your home’s circuit breaker.
Problem: The machine will not brew.
Solution:
- Make sure there is water in the reservoir.
- Make sure the reservoir is properly installed
Problem: Chlorine or mineral taste in coffee.
Solution:
- Consider using bottled or filtered water.
Problem: Doesn’t brew a full cup.
Solution:
- Turn off and unplug the machine for 30 seconds or more. When you plug the machine back in, be sure to turn the power back on.
- Decalcify the machine (refer to page 8).
Problem: SHORT /LONG buttons flash quickly; all buttons are non-functional.
Solution:
- Indicates the coffee boiler detects high temperature. Unplug the unit, and let it cool down for approximately 10 minutes.
Problem: MANUAL, and TEMPERATURE buttons flash quickly for 10 seconds after preheat/ready mode.
Solution:
- Indicates that the unit needs to be decalcified. Please follow the decalcification procedure on page 8.
NOTE: The unit can still be used until you decalcify.
WARRANTY
This warranty is available for U.S. customers only. We recommend that you visit our website, www.cuisinart.com for a fast, efficient way to complete your product registration. However, product registration does not eliminate the need for the consumer to maintain the original proof of purchase to obtain the warranty benefits.
BEFORE RETURNING YOUR CUISINART PRODUCT
If your Cuisinart® Buona Tazza® Single Serve Espresso & Coffee Machine should prove to be defective within the warranty period, we will repair or, if we think necessary, replace it. To obtain warranty service, please call our Consumer Service Center toll-free at 1-800-726-0190 or write to Cuisinart, 7475 North Glen Harbor Blvd., Glendale, AZ 85307. To facilitate the speed and accuracy of your return, enclose $10.00 for shipping and handling.
©2015 Cuisinart
150 Milford Road
East Windsor, NJ 08520
Printed in China
