Orbegozo HCE 73 Ceramic Catalytic Gas Heater
IMPORTANT ADVICE
Read the Orbegozo HCE 73 Ceramic Catalytic Gas Heater User Manual carefully. It has important information both for operational use and for your safety. Do not start up faulty apparatus. SAFETY RECOMMENDATIONS
- Use only in a well-ventilated area.
- Pay special attention when using the heater in the presence of children, the elderly, the disabled, or animals.
- Do not ever put a container of water on the stove.
- Follow carefully the installation instructions and if there is a smell of gas:
- Close the tap on the gas regulator.
- Open the windows.
- Do not operate any electrical switch and put out any flame.
- Never replace the hose and the regulator with products that do not comply with national regulations. Contact a technical service in case of doubt.
INSTALLATION RECOMMENDATIONS
It is important to follow the legal regulations in force in the states to the location and operation of this device, we recommend you consult a qualified technician. But if you decide to do without such consultation, then you relate the most important.
Required accessories
- 1 gas bottle of butane or propane, bottled only by official distributors.
- 1 standardized specifications pressure regulator.
- 1 flexible gas tube with at least 0.5m
- 2 screwed collar clips for the flexible tube. To identify these elements, consult the specifications plaque and contact your gas distributor.
- Check the characteristics plate and contact your gas provider.
ASSEMBLING
Once the heater has been taken out of its packaging:
- Remove the back panel from inside the apparatus.
- Connect the flexible tube to the gas inlet coupling of the heater and the regulator, ensuring a gastight fit with the collar clips well screwed down. Avoid twisting the hose.
- Fit the back panel using the attached fixing lugs.
CHECKING FOR GAS LEAKS
Before performing the test, extinguish all the flames and turn off all the electrical appliances. Do not smoke while checking for gas leaks.
- The test must be performed outdoors or in well-ventilated rooms.
- Check that the gas valve is closed.
- Prepare a solution of water and soap using equal amounts of each one.
- Open carefully the valve.
IGNITION INSTRUCTIONS
Attention: before using the apparatus for the first time and after long periods of non-use, we recommend switching on the control buttons several times alternately and without gas flow to facilitate working. The heater can be regulated to three different heat intensities (B): MAXIMUM (4), MEDIUM (3), and MINIMUM (2). Position 1 is used to turn on the heater, and it is also the minimum level. The switch-on mechanism is piezo-operated (A).
- Open the gas valve.
- Press the power controller and turn it to Position 1 (Ignition/Low).
- Keep pressing the power controller for 10 seconds.
- Press the piezoelectric sparker several times while still holding down the power controller. Once the flame is on, keep it pressed for a few seconds and then release it.
MAINTENANCE
- We would recommend that you have a service carried out every two years by an authorized technician.
- Watch the pilot light, which should be stable.
BEFORE CALLING IN TECHNICAL SERVICE
The heater doesn’t turn on
- Check to see if there is gas in the bottle and that the regulator is correctly coupled in the open position.
- Check to see that the tube is connected.
- Check that the instructions have been followed correctly.
The heater goes out
- If it goes out on completing the ignition instructions, repeat the operation, following the instructions faithfully.
- If it goes after 30 minutes, it is signaling that it is operating in a stuffy atmosphere. Ventilate the room and reignite the heater.
Sonifer,S.A. Avenida de Santiago, 86
30007 Murcia España
E-mail: sonifer@sonifer.es
MADE IN P.R.C.
