jocel JDE002129 DEHUMIDIFIER User Manual

jocel JDE002129 DEHUMIDIFIER

Read and Save the jocel JDE002129 DEHUMIDIFIER User Manual.

Please keep this manual carefully for further reference!

Thank you for selecting our super-quality dehumidifier. Please be sure to read this manual carefully before using it. Any questions, please contact the professional service for help. Keep the manual for future reference. The dehumidifier will remove excess moisture from the air, creating a comfortable environment for your home and Office. Its compact design allows you to easily move it to every room.

CAUTIONS

Please read the operating instructions carefully before using your dehumidifier for the first time.

1. Install the unit on the flat and hard floor to diminish vibration or noise.
2. Never immerse the unit in water or other liquids.
3. Never operate the unit if the cable or other connector is damaged, or something abnormal happens, please call customer service for help.
4. Disconnect the unit from the power supply when it is not in use, or before relocating or cleaning it.
5. Operate the unit only at the voltage specified.
6. The unit is for indoor use only. Don’t use it for other purpose.
7. Do not put heavy objects on the appliance.
8. Do not tip the unit to any side as spilt water could damage the appliance.
9. Never insert any other object into the unit body to avoid any hazard or unit failure.
10. Do not put the unit close to heat-generating devices or near flammable and dangerous materials..

INSTALLATION

Install the unit on hard & flat floors, and keep the room ventilated. Leave at least 20cm of space around the unit (when the water pipe is not connected).

1. Insert the water pipe into the drain hole on the rear panel.
2. Connect the water pipe to the bathroom, outdoors, or a container, such as a bucket.

NOTE:

1. Do not block the drainage port or water pipe.
2. Do not fold the water pipe or make it 1.5m higher than the bottom of the unit.
3. Do not replace the rubber adaptor of the water pipe, it’s a special accessory for the unit only, another adaptor may not fit the unit. If it’s damaged or lost, please call customer service for a replacement.

PARTS

Front

Back

 

SPECIFICATIONS

OPERATIONS

Indicators

1. Power indication When power is on, whether it is running or not, the power indicator shows a blue
2. Water full indication When the water tank is full, the indicator light shows red and the unit will bizz 5 times and then stop. You must empty the water tank and put it back in to correct position.
3. Timer indication When the time is on or the timer is off, the indicator light shows a blue
4. Low fan speed indication When running at low fan speed, the low fan speed indicator shows a blue
5. High fan speed indication When running in high fan speed, the high fan speed indicator shows red
6. Drying clothes indication When this light is on the light shows blue and the machine is in Dry Cloth mode the machine will keep dehumidifying continuously and the fan is on High speed as default.
   

   

7. Reminding Cleaning air filter indication When the machine has worked for 600 hours, the indicate light will show red and flicker, it indicates the air filter should be cleaned.
8. Double 8 “ Display
   This indicator shows 3 functions as below:
   1. When the power is on, it shows indoor humidity
   2. When you adjust humidity, it shows the selected humidity data
   3. When the timer is on/off, it shows the timer data

Control Panel

Power button Press this button to turn on the machine, and the machine starts to work in ordinary mode. (The humidity setting is 50%RH and the fan speed is high speed as default). The compressor will start to work after the fan has worked for 2 seconds, the indicator light will show blue and the ionizer will start to work as default. Press this button again, the machine stops working. The display shows the current humidity and the machine will be in ready mode. The fan will turn off after 10 seconds and the power indicator and fan speed indicate light will turn off.

Timer button Press this button to set the timing to turn on / turn off for 0~24 hours, press one time to plus one hour and the display shows the hours you had set. if you would like to cancel the timer setting, press this button to 00 shown on the display

Humidity increase setting button

Press this button to adjust humidity as follows (The initial humidity is 60%), you can plus the humidity as you want, and it will show as below: 60%-65%-70%-75%-80%. When the indoor humidity is lower than the set humidity, the machine would stop automatically.

Humidity increase setting button  Press this button to adjust humidity as follows (The initial humidity is 60%), you can minus the humidity as you want, and it will show as below 20%-25%-30%-35%-40%-45%-50%-55%-60%. When the indoor humidity is lower than the set humidity, the machine would stop automatically.

Fan speed setting button Press this button to adjust the fan speed between HIGH, and LOW fan speed.

Dry cloth button Press the button to start the dry cloth function, the humidity setting will be 20% and the fan speed will be high speed.

WATER DRAINAGE

Water Tank

The Water full indication will show red when the water tank is full, the warning will be given when capacity 1.5L has been reached. Take out the water tank, and empty the water inside. Put the water tank back into the dehumidifier

How to empty the water tank

1. Pull out both sides of the water tank as below.
2. . Empty the water tank.

Cautions!

1. Do not remove the float from the water tank; otherwise, the machine will not stop working when the water tank is full. Then the water will overflow which may damage your floor.
2. Drain the water collection tank completely when the water tank is full and reset your setting
3. If the water tank is dirty, clean by cool water or warm water, cannot use cleaner, steel wool, chemical rag duster, gas oil, benzene, thinner, or other solvent to clean it, otherwise, it would damage the water tank and lead to leakage
4. When putting the water tank back into the unit, please use two hands to push the water tank into the machine to the correct position. Or the water full indication will still show red and the machine cannot work.

Continuous drainage

1. Open the cover on the back of the dehumidifier.
2. Take out the water tank
3. Insert a PVC pipe with 9.5mm and 1m length (supplied), and put the other side into a container, such as a bucket

Step:

1. At the back, you can find the hole for the tube entrance.
2. . Insert the pipe into the hole of the water outlet port
3. Put the drain pipe in the specific location

CAUTION:

1. Never block the water outlet or the pipe, water will flow into the water tank if it is blocked.
2. Never bend the drainage pipe and be always lower than the outlet.
3. Must close the cover when no need for continuous drainage.

MAINTENANCE

NOTE: TURN OFF THE UNIT AND UNPLUG IT BEFORE ANY MAINTENANCE OR REPAIR TO AVOID ELECTRIC SHOCKS.

Cleaning

Unplug the unit before any cleaning. Clean the housing with a soft moisture cloth. Do not use chemical solvents (such as benzene, alcohol, or gasoline). Do not sprinkle water on the unit.

Air filter

The unit is equipped with washable air filter. Take out the washable filter. After the cleaning operation, insert the filter back into its place. Clean the washable filter every 2 weeks. If the filter is blocked with dust, the efficiency will be reduced. Wash the air filter by immersing it gently into warm (about 40°) water with a neutral detergent, rinse it, and dry it thoroughly in a shaded place.

1. Take out the filter
2. Clean the filter
   • ATT:
     1. Use the vacuum with its brush attachment to safely remove any dust.
        
3. Assemble the filter Insert the filter back into the machine slowly after washing

Dehumidifier storage

1. Unplug the unit and fold up the power supply cord.
2. Remove and clean the air filter, allow it to dry completely, and reinstall it.
3. Store the dehumidifier in a cool, dry location, away from direct sunlight, extreme temperature, and excessive dust.

TROUBLESHOOTING

BEFORE CALLING FOR SERVICE

It may save you expenses and time. This list includes common occurrences that are not the result of a defect in workmanship or materials.

Auto Defrost, Low temperature work

5℃ ≤ temperature ≤ 10℃, the machine would defrost automatically every 30 minutes 11℃ ≤ temperature ≤ 18℃, the machine would defrost automatically every 45 minutes

Note: If the water full indication is often on, there may be some malfunction in the unit. Contact a service professional for help.

Cautions:

Switch off the unit and unplug it immediately if anything abnormal happens. Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities. Contact your local government for information regarding the collection systems available.

GENERAL WARRANTY TERMS

1. The warranty is valid only on the presentation of the invoice of purchase.
2. The warranty does not cover damages for personal injury or damage caused directly or indirectly in any capacity whatsoever.

THE WARRANTY EXPIRES

1. With the modification or disappearance of the nameplate of the appliance.

TECHNICAL ASSISTANCE

• Telef. 00 351 252 910351
• Fax: 00 351 252 910367
• E-mail: assistencia@jocel.pt
• http://www.jocel.pt

We declare on our own responsibility that the machine indicated below

• Product DEHUMIDIFIER
• Brand JOCEL
• Model JDE002129
• Low Voltage 2014/35/EU
• Electromagnetic Compatibility 2014/30/EU
• Country of Origin: P.R.C.

Download Link

Get Manual