Dirt Devil Endura Max Upright
WARNING
IMPORTANT: READ CAREFULLY BEFORE ASSEMBLY AND USE. THIS PRODUCT IS INTENDED FOR HOUSEHOLD USE ONLY. IF USED COMMERCIALLY WARRANTY IS VOID. IMPORTANT SAFETY INSTRUCTIONS
- Fully assemble before operating.
- Operate the cleaner only at the voltage specified on a data plate on the bottom of the cleaner.
- Do not leave the appliance when plugged in. Unplug from the outlet when not in use and before cleaning or servicing.
- Do not use it outdoors or on wet surfaces.
- Do not allow it to be used as a toy. Not intended for use by children aged 12 and under. Close attention is necessary when used by or near children. To avoid injury or damage, keep children away from the product, and do not allow children to place fingers or other objects into any openings.
- Use only as described in this manual. Use only the manufacturer’s recommended attachments.
- Do not use a damaged cord or plug. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to a service center for inspection before continuing use.
- Do not pull or carry by cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Do not place the product on the cord. Do not run the appliance over the cord. Keep the cord away from heated surfaces.
QUICK START
- INSERT HANDLE WAND INTO TOP OF VAC. SECURE YOUR HOSE HERE.
- NOW, WRAP THE CORD AROUND THE CORD HOOKS! *
- PUSH HERE AND PULL THE HANDLE BACKWARDS TO RECLINE
- PLUG IN THE CORD AND PRESS HERE TO POWER UP.
HEIGHT ADJUST
THE FOLLOWING HEIGHT SETTINGS ARE RECOMMENDED FOR MAXIMUM CLEANING PERFORMANCE.
- Low Settings – Two Positions: Great for tile, hardwood, linoleum, and low pile carpets.
- High Settings – Two Positions: Great for plush and shag carpets.
CORD RELEASE AND STORAGE
- Before using, grasp the end of the plug and pull to release the cord from the cord reel until the red tape is reached.
- To return the cord for storage, hold the plug and press down the Cord Release Pedal on the side of the cord reel.
TOOLS
QUICK RELEASE CLEANING WAND
- Press the wand release button.
- Pull the wand up & out and insert the hose into the wand
- 3. Push the tools on the wand* for convenient cleaning. When you’re done, twist & pull to take them off.
TOOLS
COMPLETE ON-BOARD TOOLKIT
- 2-IN-1 COMBO TOOL: Use the Crevice Tool for tight spaces, corners, and stair edges, and baseboards. Try the Dusting Brush for furniture, table tops, lamps, blinds, and more. Press the lock button (A) down and slide to switch between mode
TURBO TOOL®: For upholstered furniture, draperies, mattresses and stairs.
- EXTENSION WAND: Attach to cleaning wand for longer reach on above and hard floor cleaning.
ABOVE FLOOR CLEANING
- Remove Quick Release Cleaning Handle Wand for convenient above-floor cleaning.
- Insert the hose into the handle wand.
- Attach extension wand and 2-in-1 tool for improved cleaning.
HOW TO
EMPTY THE DIRT CUP
- Dump the dirt when it’s full. 2. Push the release button (A) then pull out the dirt cup.
- Push the release button (A) then pull out the dirt cup.
- Now ditch the dirt by pushing the lower button (B). Wipe it to remove dust.
- Place back in the bottom first. Push the top of the cup against the back panel and it’ll click into place
CLEAN THE RINSABLE FILTER
- Remove the dirt cup. Twist the handle to remove the top from the dirt cup. Gently remove the filter from the handle.
- Tap clean into a trashcan.
- All pieces are printable. Allow to dry 24 hours before using
- TWIST the filter back into the handle, place the handle back on the dirt cup, and twist to close. Replace the dirt cup with the vacuum
CLEAN THE EXHAUST FILTER*
- Push the tab on the front of the cover to pivot out.
- Pull out the filter, rinse dirt from both sides, and let air dry for 24 hours before reinstalling or until dry
- Put the dry filter back. Now line up the filter cover with the bottom tabs first and then snap back into place.
$CLEAN THE CYCLONIC ASSEMBLY
- Twist counterclockwise to open the dirt cup. Pull cyclonic assembly out of dirt cup.
- Use the Dusting Tool to clean the cyclonic assembly
CLEAN THE BRUSH ROLL
- Turn your vacuum over. Use a Phillips screwdriver to take off the 6 screws. Remove the bottom plate.
- Clean the brush roll.
- Slide on the belt with the lettering on the outside.
REPLACE THE BELT
NOTE: Any other servicing should be done by an authorized service representative. If the appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water,
take it to a service center before continuing use.
- Turn your vacuum over. Use a Phillips screwdriver to take off the 6 screws. Remove the bottom plate.
- Then take off that old belt. Slide on a new belt with the lettering on the outside.
- Slip the belt around the brush roll in an area without bristles (A) and metal pin (B). Each end of the brush roll will fit into pockets on each side of the nozzle (C).
Put the plate back on and screw it together.
LUBRICATION:
The motor and brush roll are equipped with bearings that contain sufficient lubrication for their lifetime. The addition of lubricant could cause damage. Do not add lubricant to the motor or brush roll.
TROUBLESHOOTING
LIMITED WARRANTY
SERVICE INFORMATION & LIMITED WARRANTY FOR DIRT DEVIL® PRODUCTS If this product is not as warranted, contact the Dirt Devil® Consumer Response Center at 1-800-321-1134. Please have available the proof of purchase and model number for the warranted product.
WHAT THIS LIMITED WARRANTY COVERS:
This limited warranty is provided by Royal Appliance Mfg. Co., doing business as TTI Floor Care North America (referred to hereafter as “Dirt Devil”) applies only to products purchased in the U.S. (including its territories and possessions), at a U.S. Military Exchange, or in Canada. Parts and replacements may be new, refurbished, lightly used, or remanufactured, at Dirt Devil’s sole discretion. If parts and replacements are unavailable, we may, at our discretion, provide a similar product of equal or greater value, a store credit (if applicable), or a refund of the actual purchase price at the time of the original purchase, as reflected on the original sales receipt.
WHO THIS LIMITED WARRANTY COVERS
This limited warranty extends only to the original retail purchaser, with original proof of purchase from Dirt Devil or an authorized dealer of Dirt Devil products, in the U.S., U.S. Military Exchanges, and Canada.
WHAT THIS LIMITED WARRANTY DOES NOT COVER:
This warranty does not cover the use of the product in a commercial operation (such as maid, janitorial, and equipment rental services, or any other income-generating activity); improper maintenance of the product; the product if it has been subject to misuse, negligence, neglect, vandalism, or the use of voltages other than that on the data plate of this product. This warranty does not cover damage resulting from an act of God, accident, owner’s acts or omissions, service of this product by other than Dirt Devil or a Dirt Devil authorized service provider (if applicable), or other acts beyond the control of Dirt Devil.
OTHER IMPORTANT TERMS
This warranty is not transferable and may not be assigned; any assignment made in contravention of this prohibition is void. This warranty shall be governed and construed under the laws of the state of North Carolina. The Warranty Period will not be extended by any replacement of batteries or parts or repair performed under this warranty. THIS WARRANTY IS THE EXCLUSIVE WARRANTY AND REMEDY, AND ALL EXPRESS AND IMPLIED WARRANTIES OTHER THAN THE LIMITED WARRANTY SET FORTH ABOVE, INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE EXPRESSLY DISCLAIMED.
Some states do not allow the exclusion or limitation of incidental or consequential damages, disclaimers of implied warranties, or limitations on the duration of implied warranties, so the above exclusions, disclaimers, and/or limitations may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state.
