CONAIR BE200 LIGHTED MAKEUP Mirror
IMPORTANT SAFETY INSTRUCTIONS
WHEN USING ELECTRICAL FURNISHING, BASIC PRECAUTIONS SHOULD ALWAYS BE TAKEN,
INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS BEFORE USING THIS FURNISHING
DANGER TO REDUCE THE RISK OF ELECTRIC SHOCK, ALWAYS UNPLUG THIS FURNISHING FROM THE ELECTRICAL OUTLET BEFORE CLEANING OR SERVICES AFTER CLEANING.
WARNING
TO REDUCE THE RISK OF BURNS, FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS:
- Unplug from the outlet before putting on or taking off parts.
- Close supervision is necessary when this furnishing is used by or near children or individuals with certain disabilities.
- Use this furnishing only for its intended use as described in these instructions Do not use attachments not recommended by the manufacturer.
- Never operate this furnishing if it has a damaged cord or plugs if it is not working properly if it has been dropped or damaged, or if it has been dropped into water. Return the mirror to a Service Center for examination and repair.
- Keep the cord away from heated surfaces.
- Never drop or insert any object into any opening.
- Do not use outdoors.
- Do not operate where aerosol (spray) products are being used or where oxygen is being administered.
- To disconnect, turn all controls to the OFF position, then remove the plug from the outlet.
- Do not leave the appliance unattended when it is plugged in.
FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
To reduce the risk of electric shock, this mirror has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Never use an extension cord unless the plug can be fully inserted. Do not change the plug in any way.
- Your lighted makeup mirror will adjust to different angles. Simply tilt the mirror housing back and place the metal brace in the desired slot on the bar.
- Insert the plug into any standard wall outlet (120-volt AC).
- To turn on the light, simply press the power button on the side of the mirror and then push the mode switch button on the front of the mirror for the desired light setting.
- After use, switch the power button to off, unplug, and store the mirror in a safe location.
CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH THE WIDE BLADE OF THE PLUG TO THE WIDE SLOT, AND FULLY INSERT.
CAUTION:
RISK OF FIRE, USE ONLY 6.5 WATTS MAXIMUM 120 VOLTS, TYPE T BULBS.
DISCONNECT FROM THE SUPPLY CIRCUIT BEFORE SERVICING OR CLEANING. DO NOT SUBMERGE
MODEL: BE200 RATING: 120V AC 60Hz 0.12A 6.5W
GET TO KNOW YOUR LIGHTED MAKEUP MIRROR
FEDERAL COMMUNICATIONS COMMISSION NOTICE
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, under Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used by the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
SUPPLIER’S DECLARATION OF CONFORMITY
Brand: CONAIR®
Model No.: BE200
Description: Lighted Mirror Responsible Party: Conair Corporation, 1 Cummings Point Road, Stamford, CT 06902 (203) 351-9000 Standards: FCC Part 15 Subpart B, ANSI C63.4-2014 This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
DATE OF ISSUE: 11/10/2020
MAINTENANCE
Your lighted mirror is designed for household use and is virtually maintenance-free. No lubrication is needed. If cleaning becomes necessary, disconnect the appliance from the power source and wipe the exterior with a damp cloth. Clean mirror surfaces with a glass cleaner. If any abnormal condition occurs, unplug the lighted mirror, allow it to cool, and return it to an authorized service representative for repair.
SAFETY WARNINGS
If the mirror is not in use, disconnect it from the electrical outlet. BE SURE DIRECT SUNLIGHT WILL NOT STRIKE MIRROR WHEN LEFT UNATTENDED; reflected sunlight may cause fire. Allow it to cool to room temperature before storing. Place in a cool, dry area, out of reach of children, and where it will not be damaged. Handle the cord carefully for a longer life. Do not jerk or strain at plug connections or wrap the cord around the mirror for storage. This could cause the cord to become damaged and short-circuit. To store the mirror, coil the cord loosely and place it in large loops next to the mirror or secure the cord with a twist tie.
WARNING:
IF YOU THINK THE POWER IS OFF WHEN THE SWITCH IS OFF, YOU’RE WRONG. KEEP AWAY FROM WATER Everyone knows that electricity and water are a dangerous combination. But did you know that an electric appliance is still electrically live even if the switch is off? If the plug is in, the power is on. So when you are not using your appliances, keep them unplugged.
ALWAYS UNPLUG SMALL APPLIANCES
LIMITED WARRANTY
LIMITED ONE-YEAR WARRANTY (U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your unit free of charge for 12 months from the date of purchase if the appliance is defective in workmanship or materials. To obtain service under this warranty, return the defective product to the service center listed below, together with your purchase receipt. California residents need only provide proof of purchase and should call 1-800-3-CONAIR for shipping instructions. In the absence of a purchase receipt, the warranty period shall be 12 months from the date of manufacture.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR LIABILITIES, INCLUDING BUT NOT LIMITED TO THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL BE LIMITED IN DURATION TO THE 12-MONTH DURATION OF THIS WRITTEN, LIMITED WARRANTY. Some states do not allow limitations on how long an implied warranty lasts, so the above limitations may not apply to you. IN NO EVENT SHALL CONAIR BE LIABLE FOR ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER.
Some states do not allow the exclusion or limitation of special, incidental, or consequential damages, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. Please register this product at www.conair.com/registration For info on any Conair product, call 1-800-3-CONAIR or visit us on the web at www.conair.com
Service Center
Conair Corporation Service Department
7475 North Glen Harbor Blvd. Glendale, AZ 85307 ©2021 Conair Corporation 20PM075326
