HyperX Clutch Gladiate Wired Xbox
Overview
- Analog sticks (L3/R3)
- Xbox button
- Power LED
- ABXY buttons
- View button
- D-Pad
- Share button
- Menu button
- Trigger locks
- P1 button
- P2/P3 buttons
- 3.5mm headset jack
- Bumpers (LB/RB)
- Triggers (LT/RT)
- USB-C port
- USB-C to USB-A Cable
Setup
Connect the controller with the provided USB cable to your Xbox or PC.
Programmable Buttons
Assign/Re-Assign P2 & P3
Hold P1 and Release when the LED is slowly flashing.
When the LED is flashing slowly, press one of the following buttons to assign.
When the LED is flashing rapidly, press either P2 or P3 to assign your selected button.
Clear individually P2 or P3
When the LED is flashing slowly, press either P2 or P3 to clear its button mapping.
Clear both P2 & P3
Hold P1 for 5 seconds. The LED will flash slowly and return to solid when complete.
Trigger Locks
Move the slider to position 1 to unlock the full trigger motion.
Move the slider to position 2 to lock and reduce trigger motion.
Questions or Setup Issues?
Contact the HyperX support team or see the user manual at hyperx.gg/support
WARNING: Permanent hearing damage can occur if a headset is used at high volumes for extended periods.
Simplified Declaration of Conformity
Hereby, HP declares that the radio equipment complies with Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.hp.eu/certificates (search with Model Name) UK only: Hereby, HP declares that the radio equipment complies with the relevant statutory requirements. The full text of the declaration of conformity is available at the following internet address: www.hp.eu/certificates (search with Model Name)
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, according to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and if not installed and used by the instructions, may cause harmful interference to radio communications.
- Reorient the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction manual. Warning: A shielded-type power cord is required to meet FCC emission limits and also to prevent interference to the nearby radio and television reception. Only the supplied power cord must be used. Use only shielded cables to connect I/O devices to this equipment.
CAUTION: Any changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
India RoHS Statement
This product, as well as its related consumables and spares, complies with the reduction in hazardous substances provisions of the “India E-waste (Management and Handling) Rule 2016.” It does not contain lead, mercury, hexavalent chromium, polybrominated biphenyls, or polybrominated diphenyl ethers in concentrations exceeding 0.1 weight % and 0.01 weight % for cadmium, except for where allowed under the exemptions set in Schedule 2 of the Rule.
©Copyright 2022 HyperX and the HyperX logo are registered trademarks or trademarks of HP Inc. in the U.S. and/or other countries. All registered trademarks and trademarks are the property of their respective owners
